Switches
TP-Link Business Switches are comprised of JetStream series and LiteWave series, which are designed to offer reliable and professional choices to businesses of all sizes. Anything related to TP-Link's JetStream or LiteWave Switches, welcome to ask questions, join discussions and share your experience/ knowledge here.
Switches
I recently figured out how to use the Gateway Stateful ACL, which, as a network novice, I find to be the simplest to understand. I've set up some basic ACL rules to block traffic between my VLANs: my
Switch ACLVLAN & Multi-Networks
1Helpful
161Views
After posting this and thinking that I understand at least something about switch ACLs I'm stuck at this scenario: I have VLAN 20 and VLAN 60 and they must be mutually completely isolated with two exc
VLAN & Multi-NetworksSwitch ACL
By
SasoC
0Helpful
168Views
I have SG3428X-M2 L2+ switch with V1.20 firmware. I managed to create VLANs, specific DHCP IP ranges for VLANs and I think I understand this. Then I start digging into switch ACL with purpose to isola
VLAN & Multi-NetworksSwitch ACL
2Helpful
307Views
Hi everyone. I just finished updating my home network with omada hardware: 1. OC300 2. ER7206 3. TL-SG3210XHP-M2 4. TL-SG3210 5. TL-SG2008p and 4 EAPs and so on. Problem ist, that I have a raspberrypi
Switch ACLConfigurationadguard
1Helpful
391Views
Knowledge BaseAn alternative to Gateway Stateful ACL using Switch ACL
Hey All, The configuration below is to show an alternative to Stateful Gateway ACL that you can use in your Layer 3 Switching environment (i.e. using Switch for InterVLAN routing). Edit note: There ar
ConfigurationSwitch ACLHighlighted Thread
By
Death_Metal
· Latest post 2024-05-01 18:41:59
by EricPerl
9Helpful
1415Views
Good day! I'm setting up some VLANs with a TP-Link router, switch and access point. Setup: Internet --> router --> switch. I created Vlan2 and Vlan3 with interfaces and acls, but there is also the bui
VLAN & Multi-NetworksSwitch ACL
1Helpful
265Views
Hi all, I'm redoing my network and I had some questions about the best practices for employing multiple trunks (without a LAGG) from my router (OPNSense) to my TL-SG3428X-M2 switch. Currently my setup
VLAN & Multi-NetworksSwitch ACLConfigurationStatic Routing
1Helpful
353Views
Not sure if many have seen the latest Unifi Release about a week ago but a couple of their ACL features caught my attention. Unifi have new ACL features, specifically L3 Network Isolation and Device I
Switch ACLHighlighted Thread
By
Death_Metal
· Latest post 2024-03-29 13:35:59
by Death_Metal
1Helpful
584Views
Hi, My hardware setup: ER605, OC200, SG2428P, and some AP. I created few VLANs, that seems to work fine ( ADMIN, CAM, IOT, PC). An ACL was created to block any communication from all othen VLANs. But,
VLAN & Multi-NetworksSwitch ACL
0Helpful
237Views
Attention! My switch model is SG3210X-M2 not the "HP" variant selected above. The non-"HP" model can not be selected. Hi! I'm currently trying to set up some Switch ACL rules to block DMZ traffic flow
Switch ACLConfigurationVLAN & Multi-Networks
4Helpful
765Views