Controllers
TP-Link Omada Cloud SDN integrates Omada Devices including EAPs, JetStream Switches and Omada Routers, all are centrally managed with an Omada SDN Controller. Anything related to TP-Link's Omada SDN Controller, welcome to ask questions, join discussions and share your experience/knowledge here.
Controllers
Hi there, I have a house in South-Africa where I set up an Omada supperted wifi network with a switch and various access points, all controlled by an OC200 controller. I know I can setup a VPN to conn
VLAN & Multi-NetworksVPN
0Helpful
1385Views
Hi, We have a site-to-site VPN tunnel set up bewtween two non-tplink Routers which links a Head office to a factory. Currently the Controllers and 6 AP's are based at the factory site. I've just added
AdoptionVPN
2Helpful
729Views
This post is mainly from posts released by forum customer @Death_Metal, and I would like to thank @Death_Metal and others for the quality and professional Guide sharing you have contributed to the TP-
Highlighted ThreadACLVLAN & Multi-NetworksVPN
8Helpful
5897Views
The setup I have 3 VLANs A: 192.168.20.0/24 B: 192.168.40.0/24 C: 192.168.100.0/24 This enforced in a router ER605 v2.0. This router also acts as VPN server: I have some ACLs that block traffic from A
Firmware UpdateACLVPNVLAN & Multi-Networks
0Helpful
729Views
I can connect to the OpenVPN Server configured with Omada Controller, but I can't access the local network I configured my Client-to-site VPN access and I can connect well (I am testing the connection
VPN
1Helpful
2694Views
In the Omada controller, I had the ER706W device as a gateway. For this device I have defined OpenVPN Server SSL (server-client) with port 1194 and address 192.168.aaa.0/24. I had to change my router
VPN
0Helpful
609Views
Hello, I'm having little issue with Wireguard setup which I did not manage to find a solution for. I have a wireguard running on my omada with assigned local IP 192.168.95.10 this IP is totally made u
VPN
0Helpful
993Views
Hi, I was wondering if it is possible to configure wireguard for a VLAN instead of a lossless subnet. The question is because i would like to configure application blocks, which is only possible (AFAI
VPN
0Helpful
664Views
I recently updated my Omada OC200 Controller to Firmware Version 5.13.24. After the update my OpenVPN Client-to-site Servers are no longer working. I had 3 OpenVPN servers running, each tied to the co
Firmware UpdateVPN
0Helpful
935Views
Hi, I have my existing solution at raspbery I re-direct port via NAT inside to my Raspbery and have working OpenVPN Tunnel. It took me a while to figure out, not easy task regarding routing. I bought
VPNOpenVPN
0Helpful
1282Views