General Discussion
0
VotesI have a specific question regarding improving the way tp-link routers and controllers would control attached access points to mesh networks over wired or wifi mesh. The point of this thread is that T
222Views
2
VotesHi, I am just wondering whether if there is a switch, router or modem available here that could take a WAN internet output from a CPE 710 and output it to a LAN port which supports 802.3ad for WAN agg
802.3ad
131Views
2
VotesHello all. I've decided to take on the task on learning to set up a network and have some questions. First, background. Currently my network has 2 sites, my home and a vacation home. They are connecte
139Views
2
VotesHello, What do you think would work better for the warehouse diagram below? My options are 1. Use 3x CPE710 or -- Yellow Triangle 2. Use 6x EAP620 or EAP245 -- Green Circle Or what would you recommend
111Views
0
VotesHello folks- I have been using TP-Link products for awhile and have a basic knowledge of setting up Omada products in the small buisness environment, for instance I have one place set up with 2 indoor
By
Piamus
· Latest post 2022-09-02 09:50:59 by
franklin1122
141Views
0
VotesI have three sites, each with a small network. The three are then interconnected using IPSec VPN tunnels. The primary site is my house. The other two sites are a second house (hundreds of miles away)
By
PeteT
· Latest post 2022-08-29 16:00:03 by
Roxana1122
214Views
0
VotesHi all, I have a main router with internet connection, i've added another router with the same model as with Access Point mode, i need to disable the second router (access point mode) from getting int
182Views
0
VotesHi all, I need some suggestions on how to setup my dual wan connection. I have 2 ISP's that the lines come out at the oposite side of the house and that makes a problem as only 1 lan cable goes half w
By
Sashabencic
· Latest post 2022-08-24 07:56:20 by
Sashabencic
374Views
0
VotesHi guys. Since last week I´ve used a SG1005P to power my three Raspberry Pi4. Because of using four Pi Zero around my house I decided to use PoE and save power supplies. But I also want to save the po
135Views