Business Routers
TP-Link Business Routers including Omada and SafeStream VPN series are designed for small and medium-sized enterprises demanding a flexible and secure VPN network. Anything related to TP-Link's Omada Routers or SafeStream Routers, welcome to ask questions, join discussions and share your experience/ knowledge here.
Business Routers
Hi All, I have 2 x ISP modems connected to TP-Link ER605 Router with Load Balancing feature checked, and everything else is connected to a TP-Link Jetstream switch and I am having trouble connecting t
Load BalancingPort ForwardingGateway ACLWAN / LAN Setup
0Helpful
90Views
So i have a load balancer TL-R605 connected to two internet providers through WAN. Further, i have connected my WIFI access points (TP Link WIFI 6 routers) through my load balancer. In my load balance
VLAN & Multi-NetworksLoad BalancingWAN / LAN Setup
By
SachinDatta1212
· Latest post 2023-01-31 06:29:19 by
Somnus
0Helpful
122Views
Hey there how are you guys? Here is my SETUP: TL-R600VPN + TL-SG1016D + Wireless D-Link DIR842 (as an AP) TL-R600VPN + TL-SG1016D 4 WANs = 1 for each ISP 1 LAN Port that is connected in TL-SG1016D's n
WAN / LAN SetupLoad Balancing
By
Marson
· Latest post 2023-01-19 13:51:03 by
KimcheeGUN
0Helpful
80Views
Hello, I have 2 WAN from same ISP. 2x 24 mbit. I configured load balancing mode. Transmission > Enable Load Balancing (checked). Enable Application Optimized Routing (unchecked) Enable Bandwidth Based
Load Balancing
0Helpful
209Views
Hello TP-Link I migrated from ER605 v.1 to ER605 v.2 and tried to configure Link Backup between WAN and USB Modem (both these connections work fine individually). I configured it as following: WAN Por
WAN / LAN SetupLoad Balancing
0Helpful
264Views
I have dual WAN configured on WAN/WAN1 with link backup enabled. I want to know how I can monitor and log when my ISP goes down and when it comes back up. From the attached log, I can only see when th
WAN / LAN SetupLoad BalancingWAN Backup
1Helpful
102Views
Hi, I have two connections from different ISPs in WAN1 and WAN2 port respectively. I want to configure load balancer such that WAN1 should provide internet to LAN1 port and WAN2 should provide interne
Load BalancingGateway ACLVLAN & Multi-Networks
By
Eric-jones12
· Latest post 2022-12-27 13:53:20 by
Eric-jones12
2Helpful
215Views
Hi, I was hoping the Omada app would be compatible with my TL-R470T+. No such luck. Is there any way I can get Omada functionality with my TL-R470T+? I looked for the ER605 Router, but I could not fin
Load Balancing
0Helpful
94Views
Hi all, Getting the kinks worked out of my network. I have a er7206 connected to two wireless providers using DHCP. First wan works just find that provider uses Ubiquiti. My second wan1/lan1 is using
DHCP ServiceLoad BalancingFirmware Update
2Helpful
211Views
This is a quick follow up from the previous thread. So, in short. NO, it did not work. But I found something. Forget about Load Balancing, just disable that, BUT do configure the detection on each WAN
Load BalancingVLAN & Multi-Networksstatic routing
0Helpful
147Views