
Gateways
I have ER706W-4G gateway and SG2210MP switch. I connected it over SFP ports and optical fiber. Communication is fine (physical link, ping, etc.) except communication between native VLAN1 and other VLA
VLAN & Multi-NetworksNetwork Connectivity
0Helpful
217Views
Apparently, the OpenVPN build used by the router is old and uses 1024bit keys instead of 2048bit modern keys. Is there a way to get ER605 generate 2048bit key? Is there a way to upload a custom certif
ControllerOpenVPNNetwork ConnectivityVPN
0Helpful
221Views
I have two OVPN client connections: after restart or poweroff, my ER605 CLIENT conencts only one ID1 or ID2 randomly. it happens 50\50 times. today it conencted only ID1 so i need manually disable-ena
VPNNetwork ConnectivityOpenVPN
0Helpful
418Views
The hardware version is 2.20. When I connect to Wireguard with Full Traffic enabled, I don't have internet access or access to the remote local network. When I connect with Full Traffic disabled, I ca
VPNWireGuardNetwork Connectivity
0Helpful
428Views
Like the subject says, should IPS/IDS be Enabled on the ER7206? If so, is the a KT artical that explaines these other settings in the menu? Threat Management Threat Block List Threat Allow List Signat
Network ConnectivityFirewallWAN SetupACLIDS/IDS
0Helpful
259Views
Hello! I just wanna ask for a solution on my ER605 which connected to my Omada setup using OC200. The main problem is, there are times that the gateway gives a fallback ip (169.254.x.x) and results no
RoutingNetwork Connectivity
0Helpful
308Views
Hello. I have a seemingly naive, and perhaps even stupid, question. Since I use the Omada solution at home (small, simple network), I'm wondering if I can connect an SSD/HDD drive to the router's USB
Firmware UpdateUSB ModemNetwork Connectivity
0Helpful
250Views
Hello, my ER707-M2 is forward facing my ISP and I need help configuring my ER707 to use port forwarding (Virtual Servers) to allow devices in my 2.5 G LAN port2 to see the IP address of my ISP on 2.5g
Network ConnectivityDNSNAT
0Helpful
907Views
Hello everyone, I have a customer who wants/needs to provide Wi-Fi for customers. Basically, this works, but I have the following problem. When a customer logs into the Wi-Fi, they are redirected to t
ACLNetwork Connectivity
1Helpful
555Views
Hello everyone, I’m new to Omada SDN systems, and I hope that’s the reason I can’t figure out a problem I’m struggling to interpret. I’ve set up an Omada system consisting of: 1 gateway ER605 v2.0 – f
VLAN & Multi-NetworksControllerNetwork Connectivity
0Helpful
693Views
To start off this was a previously working system until about two weeks ago when this issue started. I did not make any changes, but automatic firmware updates were enabled. A power outage did occur a
WAN SetupNetwork Connectivity
0Helpful
511Views
All, I've been fighting with this for a week, hoping someone can help. I am using two ER605s in a remote office / central office confiuration. The bottom line issue is that I can get some traffic (pin
Network ConnectivityNATRoutingVPN
By
NewUser100
· Latest post 2025-10-20 17:28:17
by NeilR_M
0Helpful
474Views
