Gateways
I have two OVPN client connections: after restart or poweroff, my ER605 CLIENT conencts only one ID1 or ID2 randomly. it happens 50\50 times. today it conencted only ID1 so i need manually disable-ena
VPNNetwork ConnectivityOpenVPN
0Helpful
665Views
The hardware version is 2.20. When I connect to Wireguard with Full Traffic enabled, I don't have internet access or access to the remote local network. When I connect with Full Traffic disabled, I ca
VPNWireGuardNetwork Connectivity
0Helpful
752Views
Hello! I just wanna ask for a solution on my ER605 which connected to my Omada setup using OC200. The main problem is, there are times that the gateway gives a fallback ip (169.254.x.x) and results no
RoutingNetwork Connectivity
0Helpful
625Views
Hello. I have a seemingly naive, and perhaps even stupid, question. Since I use the Omada solution at home (small, simple network), I'm wondering if I can connect an SSD/HDD drive to the router's USB
Firmware UpdateUSB ModemNetwork Connectivity
0Helpful
467Views
Hello, my ER707-M2 is forward facing my ISP and I need help configuring my ER707 to use port forwarding (Virtual Servers) to allow devices in my 2.5 G LAN port2 to see the IP address of my ISP on 2.5g
Network ConnectivityDNSNAT
0Helpful
2006Views
Hello everyone, I have a customer who wants/needs to provide Wi-Fi for customers. Basically, this works, but I have the following problem. When a customer logs into the Wi-Fi, they are redirected to t
ACLNetwork Connectivity
1Helpful
750Views
Hello everyone, I’m new to Omada SDN systems, and I hope that’s the reason I can’t figure out a problem I’m struggling to interpret. I’ve set up an Omada system consisting of: 1 gateway ER605 v2.0 – f
VLAN & Multi-NetworksControllerNetwork Connectivity
0Helpful
1349Views
To start off this was a previously working system until about two weeks ago when this issue started. I did not make any changes, but automatic firmware updates were enabled. A power outage did occur a
WAN SetupNetwork Connectivity
0Helpful
990Views
All, I've been fighting with this for a week, hoping someone can help. I am using two ER605s in a remote office / central office confiuration. The bottom line issue is that I can get some traffic (pin
Network ConnectivityNATRoutingVPN
By
NewUser100
· Latest post 2025-10-20 17:28:17
by NeilR_M
0Helpful
971Views
Hi! I have problem on making InterVLAN routing communication between my gateway and my switch. Guide on how I do this: https://community.tp-link.com/en/business/forum/topic/650966 https://www.tp-link.
VLAN & Multi-NetworksRoutingNetwork Connectivity
By
gabrielwang
· Latest post 2025-10-19 09:05:16
by gabrielwang
8Helpful
1690Views
I am experiencing ongoing stability issues with my ER7212PC (hardware version 1.0), which serves as my main gateway and controller in an Omada-managed network. Every few weeks, the device becomes incr
Network ConnectivityControllerDNS
1Helpful
1329Views
I'm wondering if there's a way to get my Omada box to e-mail me when it switches WANs. Or whenever WAN1 goes down. It fails-over to WAN2 and WAN3, but I'd like to know that it switched. Any ideas?
WAN SetupNetwork Connectivity
By
wilson1914
· Latest post 2025-10-10 21:58:05
by NeilR_M
1Helpful
1391Views