EAP225 Outdoor initial setup for repeater mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP225 Outdoor initial setup for repeater mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
24 Reply
Re:EAP225 Outdoor initial setup for repeater mode
2020-08-16 09:29:36 - last edited 2022-08-11 12:52:55

 

Kolobo4egggg wrote

Do you have any suggestions on pointing outdoor eaps antenas? Now i made same 90 degree low and point it each to other.

 

The antennas of an EAP-Outdoor should stand upright parallel to each other for best results. The radio waves are already transmitted at 90º to the antenna.

 

If you want to do it especially well, mount the EAP-Outdoors with some distance (10-20cm) to the wall and ensure proper grounding by using an outdoor cable with a separate ground wire (e.g., UBNT ToughCable).

 

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  1  
  1  
#24
Options
Re:Re:Re: EAP225 Outdoor initial setup for repeater mode
2021-01-31 21:22:54 - last edited 2022-08-11 12:52:55

@Robert1966 

I purchased it from Amazon for the same reasons. My outdoor shed/office is a metal building and I am not able to get stable wifi signals inside.  My intention is to mount it outside the shed, run the ethernet inside and connect it to my devices.  

Am I understanding correctly that the device will not work that way?

 

  0  
  0  
#25
Options
Re:Re:Re: EAP225 Outdoor initial setup for repeater mode
2021-02-17 14:07:10 - last edited 2022-08-11 12:52:55

@R1D2 I am a total novice here but found you response useful - can you just confirm if my basic understanding of what you said is right?

I am looking to extend my home wifi out into the garden and am able to run a Cat6 cable from my main router to the outdoor area - if I connect an EAP225 Outdoor to my main router by ethernet wire, will it enable me to 'extend' my main wifi network outside with the same SSID etc and no need to switch devices between one network or the other... 

  0  
  0  
#26
Options
Re:EAP225 Outdoor initial setup for repeater mode
2021-12-08 07:43:12 - last edited 2022-08-11 12:52:55
not sure , but I WAS assured from TP-Link Tech Supp that my CPE 210 set to Client mode and connected to a router in my shed will work !....Just config'd it, but I need to get a stand-off, 25 Ft. outdoor ethernet through the steel shed wall o the router inside. I'll letcha know if you are interested. I've got two CPE210s as AP/Client up for 3 years sending 85MBps wireless ethernet to our apartment across the street then to a router inside.
  0  
  0  
#27
Options