Switch TL-SG2008P no statistic after upgrade fw

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
1234...

Switch TL-SG2008P no statistic after upgrade fw

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
61 Reply
Re:Switch TL-SG2008P no statistic after upgrade fw
2021-06-24 00:24:11

Running 1.0.1 on TL-SG2008P and doing speedtests with a 1Gbps up and down connection freezes on the upload test and disconnects other users from network, completely bogs the network down. 

When reverted back to 1.0.0, speedtests run smooth and normally without interfering with the rest of the network.

 

Topology:

 

CenturyLink Fiber ONT

--

TL-R605

--

TL-SG2008P

-- 

Wired Connections

--

EAP245

--

Wireless Connections

 

 

If I run 1.0.1 and I plug everything into the LAN ports on the TL-R605 the speedtests run normal when they are ran through the gateway.

Just the TL-SG2008P 1.0.1 firmware.

It had me thinking I had faulty hardware at first so I had ordered a replacement on Amazon before figuring out that it was the firmware by downgrading it back to 1.0.0

I hope there is a fix soon.

  0  
  0  
#26
Options
Re:Switch TL-SG2008P no statistic after upgrade fw
2021-06-24 00:29:33 - last edited 2021-06-24 00:29:52

@710james best to open a new thread since this is a different issue to the one covered in this thread

  0  
  0  
#27
Options
Re:Switch TL-SG2008P no statistic after upgrade fw
2021-06-24 01:09:31

@bdl perhaps I will seeing as this is one of two threads mentioning the TL-SG2008P.

  0  
  0  
#28
Options
Re:Switch TL-SG2008P no statistic after upgrade fw
2021-07-08 14:24:44 - last edited 2021-07-08 14:25:16

This issue is also present on the TL-SG3428MPv1.0 with firmware 1.0.1.

 

This issue is NOT present on the TL-SG3428v2.0 with firmware 2.0.3.

 

I am also looking forward to working firmware.

  0  
  0  
#31
Options
Re:Switch TL-SG2008P no statistic after upgrade fw
2021-07-08 23:21:25
I had issues with citrix slow down after installing both the released 1.0.1 version and the beta had to roll back to 1.0.0.
  0  
  0  
#32
Options
Re:Switch TL-SG2008P no statistic after upgrade fw
2021-07-12 05:38:16

I had this issue and I found the fw beta link and applied successfully into OC200 and SG2008P switches. Apparently, the statistics problem is gone and they are running fine so far. 

I am using OC200, SG2008P and a AP with latest FW with VLANs. Infra looking good. Waiting for my router arrive to complete my set up. Cheers

  0  
  0  
#33
Options
Re:Switch TL-SG2008P no statistic after upgrade fw
2021-07-19 13:56:16

@Fae 

 

After installing Firmware Version: 1.0.1 Build 20210604 Rel.36558(Beta) on Model: TL-SG2210MP v1.0 the traffic statistics are working however POE status and budget are not reporting any data.

 

Please see attached screenshot for more info. Port 2 of the SG2210MP is uplinked to a EAP225 and should show POE in use and about 5 watts of the budget used.

File:
tplink.JPGDownload
  0  
  0  
#34
Options
Re:Switch TL-SG2008P no statistic after upgrade fw
2021-07-20 02:57:18

Dear @warllo,

 

warllo wrote

After installing Firmware Version: 1.0.1 Build 20210604 Rel.36558(Beta) on Model: TL-SG2210MP v1.0 the traffic statistics are working however POE status and budget are not reporting any data.

Please see attached screenshot for more info. Port 2 of the SG2210MP is uplinked to a EAP225 and should show POE in use and about 5 watts of the budget used.

 

Do you mean the PoE status and budget are showing up properly before you install the Beta firmware?

If you plug the EAP to other ports on the switch, would it make any difference?

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#35
Options
Re:Switch TL-SG2008P no statistic after upgrade fw
2021-07-20 12:41:11

@Fae 

 

Before upgrading to the beta firmware the poe budget and status was reporting correctly. Post upgrade to the beta firmware the poe budget and status are not working correctly. Moving to a different port does not have any affect.

  0  
  0  
#36
Options
Re:Switch TL-SG2008P no statistic after upgrade fw
2021-07-20 21:55:44

@Fae 

 

After another reboot of the switch and ap the poe status is now reporting. Thanks

  2  
  2  
#37
Options