ER605 is not switching clients to the other WAN when the one connected goes offline
ER605 is not switching clients to the other WAN when the one connected goes offline
I have 2 WAN (internet) connections connected to the ER605
I have enabled the load balancing
When WAN1 goes down (physical link is up but no internet)
- The online detection says WAN1 is offline
- The clients connected to WAN1 have no internet connection
Based on the promised features, I expect the clients to be transferred to WAN2 automatically
I have to manually put some routing policy and forcefully route all clients via WAN2
so that the clients that was connected to WAN1 initially will be able to access internet
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Puthiry hello mate
I have the same issue as you do, did you make a factory reset to your device?
After that, which parameters did you configure,
Puthiry wrote
@Clive_A Thanks for the follow up
I had reset the device and tried doing the experiment again
Now when I pull the fiber, its automatically switched to WAN2
May be I messed up some configurations as you mentioned
Thanks everyone for the help
so I can reproduce your solution?
Appreciate it
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2003
Replies: 11
Voters 0
No one has voted for it yet.