Has anyone successfully gotten through on port 8080?

I am trying to connect remotely to the camera built into the Flashforge printer I have which is on port 8080 (192.168.10.110:8080/?action=stream). I can connect locally, but cannot connect remotely. I have set up a vserver rule for it an set up port forwarding. I have a static IP and can see the port is open when checking externally. I am thoroughly confused as to why this is. Any help will be greatly appreciated.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
I assumed that the image showing port 8080 open from the outside was sufficient to show that the port is open. I can access my NAS just fine.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
So this is bizarre, I pulled up the link and it first said it wasn’t available, but I set my phone down and after about 15-20 seconds it connected. The throughput is terrible, but I did connect. I had not waited this long previously as I was used to connecting immediately.
- Copy Link
- Report Inappropriate Content
i use controller so i don't know how it is in stand alone that you use, but all port forwards go lightning fast.. there is no delay at all.
- Copy Link
- Report Inappropriate Content

Information
Helpful: 0
Views: 541
Replies: 5
Voters 0
No one has voted for it yet.