ER707M2 v1 with Firmware 1.4.2 does not auto-failover wan

ER707M2 v1 with Firmware 1.4.2 does not auto-failover wan

ER707M2 v1 with Firmware 1.4.2 does not auto-failover wan
ER707M2 v1 with Firmware 1.4.2 does not auto-failover wan
2026-07-03 04:26:21 - last edited 2026-08-24 03:36:46
Model: ER707-M2  
Hardware Version: V1
Firmware Version: 1.4.2

Same-ish issue as https://community.tp-link.com/en/business/forum/topic/867366
Difference is no Omada controller in use

 

Running ER707M2 v1 with 1.4.2
Wan1 -> Netgear Cable Modem
Lan2 -> 2.5gb Switch -> End Devices

Lan3 -> HPE 1gbe Switch -> End Devices
Wan6 -> Glinet travel router with iPhone (connectivity works)

 

Cable modem connection is down due to outage, cable modem is still issuing a IP address (192.168.100.10). 
Added Glinet travel router with iPhone on wan6 (since TP-Link tether to phone was removed)

Have to manually disconnect either physical Ethernet cable or in WAN interface on wan1 to get any packets to go via wan6 even when the router cannot ping anything (besides cable modem) on wan1. Even with Link Backup configured.

 

  0      
0
#1
Options
1 Accepted Solution
Re:ER707M2 v1 with Firmware 1.4.2 does not auto-failover wan-Solution
2026-07-13 02:50:20 - last edited 2026-08-24 03:36:46

hi  @RobertWeintraub 

Any update on this concern?

BTW, twe have released a new firmware 1.4.4 this weekend. Please upgrade to it and let us know if the same situation persists:

https://support.omadanetworks.com/en/product/er707-m2/v1/?resourceType=download

 

 

Recommended Solution
  0  
0
#3
Options
2 Reply
Re:ER707M2 v1 with Firmware 1.4.2 does not auto-failover wan
2026-07-06 06:22:46 - last edited 2026-07-06 06:25:38

Hi  @RobertWeintraub 

 

Thanks for the feedback. To understand the situation better, please let us know the following info:

When did you first notice this issue?  After upgrading the firmware to 1.4.2? Or since initial installation?

What link backup mode did you configure? Please share a screenshot.

 

 

Please configure the Online Detection Mode for the two WANs to Manual, and set the Ping and DNS Lookup to 8.8.8.8. 

If the issue persists with this setup, don't hesitate to let us know.

 

 

  0  
0
#2
Options
Re:ER707M2 v1 with Firmware 1.4.2 does not auto-failover wan-Solution
2026-07-13 02:50:20 - last edited 2026-08-24 03:36:46

hi  @RobertWeintraub 

Any update on this concern?

BTW, twe have released a new firmware 1.4.4 this weekend. Please upgrade to it and let us know if the same situation persists:

https://support.omadanetworks.com/en/product/er707-m2/v1/?resourceType=download

 

 

Recommended Solution
  0  
0
#3
Options