Separate DHCP IP range for VLAN?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Is it possible to have a separate DHCP range for a VLAN? I.e., for the default vlan 0 network, the DHCP range is 192.168.100.1/22 and then VLAN #3 is 192.168.3.1/22
I have see a post elsewhere saying Omada can do it but I cannot find any option for this. I am using controller version 5.9.9 on a ER7206 v1.0
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@crrodriguez Using the 172.16... range is good advice but I didn't know about it when I set up the network. It would take a lot of time to change because all of our phones are set up to use a specific local IP for the PBX. The reason I need a different IP range is I am trying to connect a EV charger that has an IP conflict with its service port.
- Copy Link
- Report Inappropriate Content
Create a second LAN definition under Wired Networks. Configure this with your 192.168.3.1/22 settings. You can map the VLAN3 to a different physical LAN port on the 7206 (than the one used by the default VLAN) and then wire the EV charger into that port. Configure the port as untagged, if you can't, you may need to add an Omada controlled switch into your design.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 652
Replies: 4
Voters 0
No one has voted for it yet.