I just finished setting up a separate management VLAN (10) for the controller, switches, and APs.  In the devices list, the gateway is still displayed with its default address (192.168.0.1) but the rest of the devices are displayed with their 192.168.10.x addresses.  So far, OK.

In viewing the topology map, if I select any VLAN under Network Filter then all the devices and clients associated with that VLAN are highlighted.  However, when I select the Mgmt (10) VLAN, the controller and the APs are not highlighted, only the gateway and switches are highlighted.  Is this normal?  The only changes here have been adding the management VLAN and upgrading the controller firmware (only a few minutes ago).