Product Categories
Business Community
Hi ! I came from France and I want to configure an ER605. The configuration: WAN: Livebox Pro Port4: LAN1, VLAN10, 192.168.10.0/24 Port5: LAN2, VLAN20, 192.168.20.0/24 LANs are isolated. Ports are con
VLAN & Multi-NetworksFirewall
By
LudovicG
· Latest post Thursday
0Helpful
219Views
Has anyone integrated the Omada Hotspot solution into a Hotel Property Management System system such as Opera Cloud? I dont want to have to look at a third party portal when the Omada hotspot works so
PortalWi-Fi 7Controller
By
AussieMan
· Latest post Yesterday
by Vincent-TP
0Helpful
203Views
Be default, SPF1 and WAN3 are enabled for WAN use. As ususal, I disable SFP1 and then enable WAN4 for my secondary / LTE backup. LTE wasn't working showing disconnected. So I turn off Port4 as a WAN u
WAN SetupLoad Balancing
0Helpful
222Views
I need to enable DoH in order to bypass tmobile DNS packet inspection and redirects. All of my clients point to the gateway for DNS. I have about 20 local DNS entries so they need to point to the gate
DNS
0Helpful
219Views
Hello, Could somebody please confirm to me whether or not they update this page every time a new firmware has been released - Omada Software Controller | Omada Free On-Premises Software Controller for
ControllerFirmware Update
0Helpful
226Views
Does anyone here know if the "Disable Hardware Reset" function works correctly? I think one of my access points was stolen and factory reset for reuse. I had the "Disable Hardware Reset" option enable
Network ConnectivityFirmware Update
0Helpful
164Views
Hello, I have a problem with a new TP-Link ER706W v1.0. Network topology: O2 (CETIN) FTTH Zyxel VMG4005-B60A in bridge mode ER706W connected to WAN2 PPPoE VLAN ID 848 OC200 Controller EAP225 Outdoor +
Controller
0Helpful
199Views
I purchased a ER7206 - updated it to the latest Firmware and I'm trying to set up a VPN Server, so that I can connect from outside and it should route the entire traffic through my home network, which
VPNWAN SetupRoutingWireGuard
0Helpful
279Views
Hi all, I'm little bit confused, I've seen on the forum, that there was a "Pre-Release" firmware (2.4.0) for my gateway (ER605), but it was never displayed as available in Controller. so, I would like
Firmware Update
0Helpful
276Views
Not sure where to start, i used to have a pretty decent experience on the Omada setup, recenty one of the kids came to me asking about the PS5 in the livingroom not working. It was at the time the onl
Network Connectivity
0Helpful
275Views
Description Currently, the built-in SpeedTest feature in the Omada Controller automatically selects the test server. In most cases, it does not select the user's actual ISP server, which can lead to i
SpeedTest
2Helpful
184Views
I am setting up an IPsec VPN using a Yamaha RTX1210 and a TP-Link ER605. Although the tunnel session has been established, there is an issue with packet transmission, and pings are failing to go throu
VPNIPsec
0Helpful
233Views