3DScanSTLLV1Online
Following: 0Followers: 0
Forums/ Routers
2024-11-22 21:07:21
Re:Help w/ configuring OpenVPN to allow full access to my network
@RaRu I did not know how else to describe it. This is the printer connection dialog box in Flashprint: When I connect with the vpn, I need to be able to find the printer so I can connect to it. Right...
0HELPFULS
Forums/ Routers
2024-11-22 20:33:25
Help w/ configuring OpenVPN to allow full access to my network
I have a question about configuring OpenVPN, specifically how to set it up so that once connected I have access to my entire network. I do not understand how to configure the IP blocks so that when...
0HELPFULS
Forums/ Routers
2024-11-21 17:00:44
Re:Has anyone successfully gotten through on port 8080?
@MR.S So this is bizarre, I pulled up the link and it first said it wasn’t available, but I set my phone down and after about 15-20 seconds it connected. The throughput is terrible, but I did...
0HELPFULS
Forums/ Routers
2024-11-21 16:26:19
Re:Has anyone successfully gotten through on port 8080?
@MR.S I assumed that the image showing port 8080 open from the outside was sufficient to show that the port is open. I can access my NAS just fine.
0HELPFULS
Forums/ Routers
2024-11-21 16:07:40
Has anyone successfully gotten through on port 8080?
I am trying to connect remotely to the camera built into the Flashforge printer I have which is on port 8080 (192.168.10.110:8080/?action=stream). I can connect locally, but cannot connect remotely....
0HELPFULS