Feature Request (Deco)
1
VotesMany users have already expressed the need to be able to switch off the WLAN permanently in their Deco X50-5G (Reboot persistent). Is there any feedback from TP-LINK regarding an implementation (which
By
Johnpersil
· Latest post 2025-03-19 07:31:58
by David-TP
114Views
8
VotesI live in an apartment building and one of the issues I have to face almost every other day is that my 2.4 GHz Wifi stops working near my satellite Deco due to interference from another 2.4 GHz Wifi f
optimization
3361Views
1
VotesI currently use a dynamic IP (DHCP) to obtain an IP address from my internet provider. I would like the ability to release the currently assigned IP address and request a new one, effectively renewing
210Views
1
Votesthis one was so serious problem and till date it was not solved yet, i noticed while gaming or streaming even i go outside of my home network devices was not able to communicate (packet losses over 80
By
kayyum_f388c764
· Latest post 2025-03-18 06:13:21
by David-TP
67Views
1
VotesHi! Running Deco X75 (unknown HW-version) with 1.4.3. I would like to use a pi-hole DNS running on a Raspberry Pi 2. The RP is connected to LAN, no WiFi. I point DHCP-clients to use my DNS in Deco. It
168Views
12
VotesThe Deco app shows that UPnP is enabled, but does not give me any information about what ports have been configured. I can see from another device on my network that 62 out of 64 UPnP ports are config
Port Forwarding
4471Views
1
VotesIt's really great that the access point has IPSec support. Unfortunately, the versions are just really outdated and are no longer secure. Could this be updated to the latest versions? So, IKEv2 and AE
By
_djp
36Views
0
VotesI have read this problem already elsewhere on the forum, but I like to re-raise the issue. I have a Deco X60v2 next to a camera which is used for baby-monitoring. This Deco-unit is ethernet-wired to t
preferred signal source
101Views
3
VotesFrom NextDNS (regarding DoH & Dot), you get the folowing options: DOH: https://dns.nextdns.io/2XXXX2 When I try to enter that in my Deco X50, it says invalid format. It seems it only likes the 'dns.ne
DoH/DoT
By
jijookhier
· Latest post 2025-03-12 00:32:29
by Healy903
508Views
2
VotesHello TP-Link Support and Community, I have two separate TP-Link Deco networks set up in different geographical locations, both managed under the same TP-Link ID. My goal is to connect these networks
VPN
574Views