Wi-Fi Routers
I tried to set it up as an access point, I ran the diagnostics and it said that the device (archer c64) connect to to the internet. Yes, my cables work, yes, I pluged it to the WAN port in Archer and
Access Point Mode
5Helpful
74Views
I have the router as access point mode with DHCP activated for the clients with a pool diferent from the main router, because I wanted to see if the problem was DHCP after I lost connection to the rou
Access Point ModeFirmware UpdateNo connection
0Helpful
44Views
Hi all I have had this red exclamation mark on my router (set as access point) for about a week now. The light that indicates a good WAN connection is also orange. Everything seems to be working fine
Access Point Mode
By
SnipeViper
· Latest post 2023-02-17 20:48:00 by
terziyski
1Helpful
112Views
Hi, please: No Wifi. Only with cables. I couldn't find options for this in the settings of the TL-AC1750 C7 V2. Could someone show me a step by step? Thank you very much!
Access Point ModeArcher C7
2Helpful
69Views
I am trying to setup a network but getting "WAN ip and LAN ip are in the same subnet". Here is how it looks: 1. ISP Ubiquity antenna used to have DCHP enabled, but I have asked them to disabled, to ha
Access Point Mode
1Helpful
241Views
Hi there, I have an interesting and annoying issue with the Archer C64 When Microwave is used on full power it instantly knocks out the WiFi. Now i know its normal for microwaves to cause interference
Access Point Modeinterference
By
stanley2468
· Latest post 2023-02-06 09:17:07 by
Kevin_Z
0Helpful
123Views
Hi can i connect two routers with a cable using easymesh? I have one Tp link C64 router, I plan to buy another router of the same type and connect it via easymesh so that the main router is like a rou
EasyMeshAccess Point Mode
2Helpful
369Views
Hello, I've just connect new router C6 VIA LAN cable (category 6e) in Access point mode. I see that on wifi i have 2 times faster internet than on LAN cable. VIA kable i have 80Mb/s and on WiFi about
Access Point Mode
4Helpful
46Views
Hi When I have the AX50 router in AP-mode it doen't seam to respect the DHCP options from the firewall that runs the DHCP-server for my LAN. I can see that the Archer AX50 is renewing the lease about
Access Point Mode
By
MartinBer
· Latest post 2023-01-24 18:02:22 by
Capricorn1
4Helpful
3035Views
Hello everyone. I'm trouble shooting very weak 2.4GHz performance on a newly purchased TP-Link AX1500 (AX10) running the latest firmware. The router's operating in access point mode with a 1.0gbps lin
Access Point Mode
By
mintymiller
0Helpful
104Views