Wi-Fi Routers
I have a house with a cellar, two upper floors and an attic. I operate one Archer C6 in router mode in cellar and two Archer C6 for both upper floors configured in access point mode. That works just f
Access Point ModeRoamingInstallation
1Helpful
242Views
Hello, I recently purchased a new router, the Archer C80. I'm considering whether to use it in router mode or AP mode. Could you please explain the differences between the two? Here's my setup: My ISP
Access Point Modewireless router
1Helpful
276Views
Hi TP Wizards, I have a strange problem. I originally had my 3 C64's all as access points, but after guidance from your good selves went for the mesh setup. Advised topology was: Virgin Router > ether
EasyMeshEasyMesh Ethernet BackhaulAccess Point Mode
1Helpful
216Views
Since we are still waiting for the ethernet backhaul firmware upgrade for easy mesh on this AX55, is there any performance impact on using AP mode for the satellite device/second AX 55? Or it is not r
EasyMeshFirmware UpdateAccess Point ModeEasyMesh Ethernet Backhaul
By
mamiwhereru
· Latest post 2023-11-11 07:48:10
by Basboi85
9Helpful
1514Views
I'm using AX23 as 2nd router connected via LAN cable so my setup is Main router (which is provided by the internet service provider) > 2nd router (Ax23) which is connected via Ethernet cable. Should I
Access Point ModeWDS/Range Extender Mode
3Helpful
342Views
Hello, I'm already using the second Archer C 80 Router. I returned the first one because TP Link Brasil support convinced me that it was a hardware problem. I use it in Access Point Mode and the searc
Access Point Mode
2Helpful
200Views
I have to use an Archer AX55 behind my Vodafone Station (in Router mode). For One Mesh it`s necessary to use Router mode on the Archer AX55. If the WAN-Port is connected to the LAN-Port at Vodafone St
Access Point ModeOneMeshFeature RequestEasyMesh
2Helpful
511Views
i bought new router and wanted to make second one as wireless extender. read some community threads and found that i need to update firmware. in screenshots you can see my current version, the firmwar
Firmware UpdateWDS/Range Extender ModeAccess Point Mode
By
Akbar010202
· Latest post 2023-10-29 18:28:58
by terziyski
2Helpful
257Views
Hi, I have three archer c6 ac1200 routers and I am using them all as access points for different floors of my house. I have connected them with my isp provided routes, but they all broadcast different
Access Point ModeOneMeshEasyMesh
2Helpful
460Views
Dear community I have configured the Archer C24 router in access point mode according to the instructions (Archer C24 is connected via ethernet to the main modem/router located in another floor on my
Access Point Mode
2Helpful
440Views