Deco
I have been trying to set up a VPN client (CyberGhost) for my Deco X50 and have gone through all steps indicated in the app and also tried Troubleshooting VPN Issues on Deco - Home Network Community (
2Helpful
36Views
Everytime i enable the guest wifi it makes the system crash and it needs a full restart. i am sick of all these bugs in the deco systems! restart, re install etc. Bugs stay, for this amount of money i
0Helpful
20Views
My Deco M9 Plus system log is getting flodded with these error messages every 10 seconds. I've seen other posts here 2 years ago and would hope this to have beeene fixed since. Mon Apr 22 12:22:33 202
Firmware Update
0Helpful
17Views
I just set up the router as 4G/5G with the sim and it seems to have good connection yet I get the unstable connection warning and the light on the side is yellow. The light should be blue right? The c
Network ConnectivityUnstable Connection Warning
1Helpful
56Views
WiFi internet speed dropped considerably after firmware update. Although wired connection is working fine. Also not able to downgrade firmware build to 1.4.1. Any suggestions?
Firmware UpdateNetwork ConnectivitySpeed Degradation
0Helpful
21Views
Hi, I have a Starlink internet solution and want to use the Decos to get a better signal around the house. I've set up the first Deco via the app a whilst connected it via ethernet to my Starlink rout
Network ConnectivityInstallationStarlink
0Helpful
14Views
All port forwarding rules are resetting the assigned addresses from 192.168.x.x to 192.168.0.x. Subnet mask for the unit is 255.255.252.0. This worked in the past and I'm not sure when it switched but
Port Forwarding
1Helpful
40Views
Hi, I'm experiencing weird problems with my daisy chain setup of three BE65 decos. I have setup the decos as Access Points. They are connected as a daisy chain (shown in the diagram below). In this se
Network ConnectivityAccess Point ModeDeco Ethernet BackhaulMulti-Gigabit
1Helpful
32Views
Hi, my new Deco BE65 triple set is now in use for some days and I noticed the system log is filling up with tons of messages. Especially every about 30 seconds these error messages are repeating: Fri
1Helpful
58Views
I bought a new Deco X80 yesterday and can connect to it but it cannot connect to the internet. I have copied the PPPoE settings directly from the old router but still no luck. The PPPoE Username is an
By
AlanIde
0Helpful
10Views