Deco
Greetings, great TP-Link gurus! Please excuse my English in advance. I recently got a new set of five Deco x20 (x3 pack and x2 pack) and the ISP provides me 600 mbps. First, I decided to configure the
By
Antoine_Ego
· Latest post 2020-12-01 09:51:57
by TP-Link
2Helpful
1303Views
Hello, More than eight months passed since the last firmware that implements "Guest Network" in AP mode, only that the "Guest Network" actually don't comply with the minimal requirement, be separate f
5Helpful
3670Views
Directions for the latest (all?) firmware upgrade say to use an Ethernet connection if possible. I assume, though it is not stated, this means an Ethernet connection to the main Deco, not to a Deco th
0Helpful
383Views
Power cycled my main Deco X20 and it won't reconnect. The red light stayed on. I've tested the lan cables and switch port it's connected to, and they are working fine. Reset the box to go through the
2Helpful
412Views
Hello all, Today I installed my deco m9 plus (3-pack) and everything worked fine. All the deco's were wired from de modem. I only had 1 problem: the internetspeed of my gaming PC was really slow, so I
0Helpful
2201Views
Hi, I am in Sweden and I use Verisure as my Alarm system provider. Now I have installed a new Deco P9router system to transfer the WiFi between some cottages on my ground. I used to have a Netgear sys
By
Sten_H
0Helpful
875Views
Hello, Yesterday I installed 3x E4R Deco. They all worked well. Today the lights off all deco's are solid red. Reset doesn't help. I've already searched in this community and on the internet for an an
By
LindaBra
0Helpful
337Views
Hi Support, I am trying to block several sites from my kids that are not on the pre-defined blacklist of the Deco mobile app (for my Deco M9+). More specifically, I'm trying to block the log in of rio
0Helpful
897Views
I'm on EE Fibre Max 2 I get 300 Mb wired and using the Deco app speed test but can't get above 210 on any wireless device, even right next to the main M5. I get 300 if I use the EE router It's not a b
By
Stuart0001
· Latest post 2020-11-30 11:34:11
by Stuart0001
0Helpful
289Views
0Helpful
169Views