Deco
Hello, Im looking to set up a home mesh network. I am new to the networking game and just wanted to know if this set up would work: -> Internet -> Router ( TP-Link Archer AX72 ) -> PoE Switch -> TP-Li
Network ConnectivityInstallationIoT NetworkRoaming
By
daleautech
· Latest post 2024-01-29 12:48:45
by Alexandre.
1Helpful
598Views
Hello. Today I installed the Deco X20 mesh with three nodes, one connected to my modem on the first floow, and the two others distributed througout my house (one in the hallway at the bottom of the st
Network ConnectivityRoaming
By
Jon_no
· Latest post 2023-12-27 21:08:06
by Alexandre.
0Helpful
296Views
I have 3 Deco (M4R) in my house. I also bought two M3W repeaters to increase speed in couple of remote locations. What I noticed is that in Deco apps both my repeaters have 0 connected devices. So, ev
RoamingNetwork Connectivity
By
RealSeniorUser
· Latest post 2023-11-30 03:32:03
by David-TP
0Helpful
215Views
Hi every one i hope all you fine , i received some issue last days from our employers in company there is a bug and Jam in WIFI Sharing here is pic below showing the Cuts i hope this issue is not in f
Firmware UpdateAccess Point ModeRoaming
0Helpful
551Views
Hello! I recently purchased a 3-pack X20 Mesh from TP-Link. My old Mesh was a P9 which was too slow for fiber-internet up to 250 MBit - it only goes up to 130/150 MBit where the X20 reaches it's full
RoamingNetwork Connectivity
0Helpful
463Views
I have a TP-Link VR600 router and a Deco system in Access Point mode. I want to know the best way to configure the wireless settings for both devices. 1) Should I use the same SSID and password for bo
Access Point ModeDeco Ethernet BackhaulRoamingNetwork ConnectivityVR600
By
Private3
· Latest post 2023-10-23 14:00:47
by Alexandre.
1Helpful
454Views
Good day folks, Just a query as I'm looking at buying the set of 3 Deco M4's but I don't think the documentation is very clear. The setup I'm looking at is this: OPNsense Router > 16 Port Unmanaged Sw
RoamingAccess Point ModeDecoM4
By
Craig_A4
· Latest post 2023-09-27 14:19:39
by Alexandre.
0Helpful
550Views
Hello, I am considering the XE75Pro, but first, I want to understand the roaming technology in use within the nodes (on these and generally). Is there active signal tracking an monitoring to determine
Roaming
By
MikeFdes
0Helpful
182Views
Hi, My current setup is: Router: MikroTik RB5009UG+S+IN AP: 4xDeco M4R(2.0) All Decos are wired to the router and are working in AP mode. I need 1 more Deco unit. The idea is to add X50, and replace o
Access Point ModeDeco Ethernet BackhaulRoaming
5Helpful
2502Views
Hi, I was looking at setting up the Deco X55 Mesh I'm trying to avoid NAT on NAT on NAT as I have Cable broadband in router mode, is this the best way to go ?? I do have a VR600 v3 with which I use th
RoamingDeco Ethernet BackhaulAccess Point ModeVPN
By
Garry_C999
· Latest post 2023-09-04 13:58:42
by Alexandre.
1Helpful
368Views