Unable to add Deco node when running as Access Point
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Unable to add Deco node when running as Access Point
Model :
Hardware Version :
Firmware Version :
ISP :
Firmware: 1.1.5 Build 20170820 Rel. 62483 (but also experienced the issue at firmare 1.1.3).
I'm unable to add new nodes with the Deco app running as "Access point" mode. I'm able to find a new node, but Deco won't go pass the "Checking connection" step, which according to the app should take a couple of minutes but will actually never finish. As soon as I configure the Deco in "Routing" mode I'm able to pass the "Checking connection" step within 15 seconds and I'm able to add the Deco to the network.
A workaround is to configure the Deco M5 as "Routing" mode, add all deco nodes and then switch it to "Access point" mode.
Hardware Version :
Firmware Version :
ISP :
Firmware: 1.1.5 Build 20170820 Rel. 62483 (but also experienced the issue at firmare 1.1.3).
I'm unable to add new nodes with the Deco app running as "Access point" mode. I'm able to find a new node, but Deco won't go pass the "Checking connection" step, which according to the app should take a couple of minutes but will actually never finish. As soon as I configure the Deco in "Routing" mode I'm able to pass the "Checking connection" step within 15 seconds and I'm able to add the Deco to the network.
A workaround is to configure the Deco M5 as "Routing" mode, add all deco nodes and then switch it to "Access point" mode.