TP-Link Community > Tapo Smart Cameras > NC450. Power surge during firmware update.Maybe there is a chance?
< Tapo Smart Cameras

NC450. Power surge during firmware update.Maybe there is a chance?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

NC450. Power surge during firmware update.Maybe there is a chance?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
NC450. Power surge during firmware update.Maybe there is a chance?
NC450. Power surge during firmware update.Maybe there is a chance?
2018-03-21 01:04:07
Model :

Hardware Version :

Firmware Version :

ISP :

Model : NC450

Hardware Version : V2
Firmware Version : NC450(UN)_v1.1.6_161124



Hello.

There was some power surge during firmware update. After that camera only shows fast blinking green LED. when connected to router - no info in DHCP table.
Maybe there is a way to resurrect the device? Bios dump? (some friend of mine had minipro tl866 programmer) Some sdcard bootable firmware image? Unfortunately, authorized service is not an option.

any tips/solutions will be greatly appreciated. it'll be a pity to brick such a nice device by such a minor accident.

Thanx in advance.
  0      
 
  0      
 
#1
Options
4 Reply
Re:NC450. Power surge during firmware update.Maybe there is a chance?
2018-03-21 15:10:01
factory reset doesn't help? the light is flashing green or red? it is connected to your router via ethernet cable, right? usually red means it is bad
  0  
  0  
#2
Options
Re:NC450. Power surge during firmware update.Maybe there is a chance?
2018-03-21 15:43:40
Factory reset doesn't help. Front LED is off, back LED on Reset button is flashing green. Yes, camera is connected via ethernet to Tplink router.
  0  
  0  
#3
Options
Re:NC450. Power surge during firmware update.Maybe there is a chance?
2018-03-27 14:39:30
you may contact tp-link support and ask them if they can provide replacement for you. it looks like this camera is dead.
  0  
  0  
#4
Options
Re:NC450. Power surge during firmware update.Maybe there is a chance?
2018-03-27 15:39:31
Hello, Anton L.Z.
Well, warranty is void now and the price on mainboard will be close to price of new camera (if there'll be such mainboards in stock at all).
I dont think that the camera is dead, in medical terms it's In vegetable state now :), FW is absent/not working.
  0  
  0  
#5
Options

Information

Helpful: 0

Views: 790

Replies: 4

About Us
Press
Copyright © TP-LINK CORPORATION PTE. LTD. All rights reserved.