My NC450 has issues syncing with my deco m9 plus even after I tried resetting $ standard procedures

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

My NC450 has issues syncing with my deco m9 plus even after I tried resetting $ standard procedures

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
My NC450 has issues syncing with my deco m9 plus even after I tried resetting $ standard procedures
My NC450 has issues syncing with my deco m9 plus even after I tried resetting $ standard procedures
2019-06-12 23:51:15 - last edited 2019-06-19 07:04:39
Model: NC450  
Hardware Version:
Firmware Version:

I tried several ways including pressing the reset button, switching off, deleting the camera etc but she just can’t sync with the new deco m9 plus. 

 

Pls advice if any good methods.

 

thanks! 

  0      
  0      
#1
Options
1 Accepted Solution
Re:My NC450 has issues syncing with my deco m9 plus even after I tried resetting $ standard procedures-Solution
2019-06-18 03:20:58 - last edited 2019-06-19 07:04:39

Hi,

 

Here is the instruction  to setup NC450.

https://www.tp-link.com/support/faq/821/

 

Besides, please disable the 5GHz of the Deco M9 and disable the fast roaming at first.

 

Once you setup the NC450, you can re-enable them.

 

May it help and have a nice day. 

 

Recommended Solution
  0  
  0  
#2
Options
3 Reply
Re:My NC450 has issues syncing with my deco m9 plus even after I tried resetting $ standard procedures-Solution
2019-06-18 03:20:58 - last edited 2019-06-19 07:04:39

Hi,

 

Here is the instruction  to setup NC450.

https://www.tp-link.com/support/faq/821/

 

Besides, please disable the 5GHz of the Deco M9 and disable the fast roaming at first.

 

Once you setup the NC450, you can re-enable them.

 

May it help and have a nice day. 

 

Recommended Solution
  0  
  0  
#2
Options
Re:Re:My NC450 has issues syncing with my deco m9 plus even after I tried resetting $ standard procedures
2019-06-18 15:54:42

Hi Kevin,

 

Thanks for below and it worked! Thanks for efforts in solving this problem.

 

Rgds

  0  
  0  
#3
Options
Re:Re:Re:My NC450 has issues syncing with my deco m9 plus even after I tried resetting $ standard procedures
2019-06-19 07:04:19

Hi Bing,

 

Glad to hear that it was resolved finally. Thanks a lot for your valued reply. 

 

If need more help in the future, do not hesitate to contact us. 

 

Good day. 

 

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 577

Replies: 3