TL-R480t+ shows wan1 status disconnected, and wan2 connected. Both connections are working fine
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R480t+ shows wan1 status disconnected, and wan2 connected. Both connections are working fine
Hi to everyone.
I have a TL-R480T+ smb load balance broadband router.
I've configured 2 wan connections.
The first is a Telmex Modem with the IP Address 192.168.10.254
The second is a TotalPlay Modem with IP Address 123.10.10.1
Yesterday I configured this device, and both connections are working on system Status.
Today, I see my web interface and the first connection is Not Connected.
Also, if I connect the Telmex connection to a computer, the internet service is currently working.
The second connection always shows Status Connected.
The Link Backup is configured:
| ID | Primary WAN | Backup WAN | Mode | Effective Time | Status | Operation |
|---|
| 1 | WAN1 | WAN2 | Failover | -- | Enabled |
This is the Wan Status List
WAN Status List
| ID | Port | Port Status | Operation |
|---|
| 1 | WAN1 | Offline | |
| 2 | WAN2 | Online | |
| 3 | WAN3 | Offline | |
| 4 | WAN4 | Offline |
What's hapenning with my broadband router?
can anyone tell me about this situation?