How to Configure WAN PPPoE in Access Point (AP) mode of TL-MR3020 (EU) v3.20?

How to Configure WAN PPPoE in Access Point (AP) mode of TL-MR3020 (EU) v3.20?
How to Configure WAN PPPoE in Access Point (AP) mode of TL-MR3020 (EU) v3.20?
2020-06-20 10:36:13 - last edited 2020-06-20 11:17:27
Model: TL-MR3020
Hardware Version: V3
Firmware Version: 1.3.0 0.9.1 v0001.0 Build 180907 Rel.52247n

When in Access Point (AP) mode, the Network section of the router's web-based admin console at http://tplinkwifi.net/ doesn't provide an option to set the connection type to PPPoE & provide the relevant username & password. Then how to set up PPPoE in AP mode?

 

 

NOTE: The admin console DOES allow setting connection type to PPPoE in WISP mode but my requirement is PPPoE in AP mode.

 

Following are the Quick Setup screens:

 

 

 

 

 

 

harishkm.in
0
0
#1
Options
1 Accepted Solution
Re: How to Configure WAN PPPoE in Access Point (AP) mode of TL-MR3020 (EU) v3.20?-Solution
2020-06-20 11:16:47 - last edited 2020-06-20 11:17:27

I found the solution thanks to this reply. Switch the router to 3G/4G mode, & perform Quick Setup at http://tplinkwifi.net/ as shown below:

 

 

 

 

 

 

If your ISP has captured your MAC, either call them up & provide this router's new MAC or configure this router to use the MAC that's already whitelisted at the ISP, as shown below (see bottom of pic):

 

harishkm.in
Recommended Solution
0
0
#2
Options
1 Reply
Re: How to Configure WAN PPPoE in Access Point (AP) mode of TL-MR3020 (EU) v3.20?-Solution
2020-06-20 11:16:47 - last edited 2020-06-20 11:17:27

I found the solution thanks to this reply. Switch the router to 3G/4G mode, & perform Quick Setup at http://tplinkwifi.net/ as shown below:

 

 

 

 

 

 

If your ISP has captured your MAC, either call them up & provide this router's new MAC or configure this router to use the MAC that's already whitelisted at the ISP, as shown below (see bottom of pic):

 

harishkm.in
Recommended Solution
0
0
#2
Options