MR600 - Signal Reception and Carrier Aggregation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

MR600 - Signal Reception and Carrier Aggregation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
MR600 - Signal Reception and Carrier Aggregation
MR600 - Signal Reception and Carrier Aggregation
2020-08-23 17:42:53 - last edited 2020-08-24 17:42:41
Model: Archer MR600  
Hardware Version: V1
Firmware Version:

Hi Support  , @Kevin_Z @Sunshine 

 

Hope you are safe. Please update firmware of MR600 for good reception of the signals with the internal antennas. The router is well built and has great LTE potential.But needs a lot of improvents at firmware level. (a suggestion). 

 

- Where a mobile phone gives  full bar , the router can't catch similar signal strength at the same place and time. The router somehow has a problem with signal reception compared to a router (ex Huawei )similar configuration and capabilities. 

- Please ask your developers to add  2CA_40A + 40A needed in India to utilise the device to the fullest.

 

~Abhi

Regards, Abhi
  0      
  0      
#1
Options
3 Reply
Re:MR600 - Signal Reception and Carrier Aggregation
2020-08-25 01:35:56

@Abhi093 

Good day.

I can see that our senior engineers have already followed up your case by email, and hope they could help you find a solution as soon as possible,

Thank you very much!

  1  
  1  
#2
Options
Re:MR600 - Signal Reception and Carrier Aggregation
2020-08-25 06:45:55

@Sunshine Am also facing this issue. Please update in firmware. Band 40+ Band 40 should be enabled as jio and Airtel supporting  it. 

  1  
  1  
#3
Options
Re:MR600 - Signal Reception and Carrier Aggregation
2020-09-25 13:00:49

@Sunshine 

 

Hello,

 

I agree with Abhi, Router needs improvement when it comes to signal strength. Mobile phones catches better signal than this router on the same place. Also in another forum we have already requested to enable 2CA_40A + 40A carrier aggregation but have not received any reply yet from TPLink.

  1  
  1  
#4
Options

Information

Helpful: 0

Views: 1809

Replies: 3