Multiple Access Points

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Multiple Access Points

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Multiple Access Points
Multiple Access Points
2020-12-17 17:10:53 - last edited 2020-12-18 03:34:11
Model: Archer C80  
Hardware Version: V1
Firmware Version: 1.5.0 Build 201022 Rel.53112n(4555)

Hi,

 

I have two C80 set as access points to my ISP router. do you know how can I make devices discoverable from one access point to another.

Here is the use case: I have a laptop that is on access point 1 and another on access point 2, but I cannot connect from laptop 1 to laptop 2

 

Below is an attempt of a network diagram.

 

Thanks in advance

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Multiple Access Points-Solution
2020-12-18 01:33:30 - last edited 2020-12-18 03:34:11

In this scenario the devices on AP1 should be accessible by devices on AP2 and vise versa. If you can ping Laptop1 from Laptop2 and vise versa, then you have an access between them. If you are trying to use SMB (file sharing service) between these two, you have to configure them with the same Workgroup name and set the Network Profile as Private, so their shared folders can be visible to each other.

Use this reference as a guide:

https://www.online-tech-tips.com/windows-10/change-from-public-to-private-network-in-windows-7-8-10/

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  5  
  5  
#2
Options
2 Reply
Re:Multiple Access Points-Solution
2020-12-18 01:33:30 - last edited 2020-12-18 03:34:11

In this scenario the devices on AP1 should be accessible by devices on AP2 and vise versa. If you can ping Laptop1 from Laptop2 and vise versa, then you have an access between them. If you are trying to use SMB (file sharing service) between these two, you have to configure them with the same Workgroup name and set the Network Profile as Private, so their shared folders can be visible to each other.

Use this reference as a guide:

https://www.online-tech-tips.com/windows-10/change-from-public-to-private-network-in-windows-7-8-10/

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  5  
  5  
#2
Options
Re:Multiple Access Points
2020-12-18 03:34:45
The workgroup was the issue. Thanks!
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 952

Replies: 2

Related Articles