Troubleshooting LED loop on Deco/ Deco stuck in solid yellow
This Article Applies to:
All Deco models
Typical Problem Description:
1. One of the Deco units was stuck in constant yellow light mode and was not able to enter setup mode (blue blinking light);
2. One of the Deco units goes into this reboot loop of Solid Yellow > Blinking Yellow > Blinking Blue > Off > Solid Yellow, this cycle keeps on repeating.
If Deco had a solid or flashing red, please have a look at this link: Deco turned red
Troubleshooting suggestions:
1. Please hold the reset pinhole at the bottom of the Deco for 1s and check whether the light could be back to yellow---flashing blue.
2. If the factory reset did not make any difference, please refer to this link to do a firmware recovery:
https://www.tp-link.com/support/faq/2958/
If the issue continues, please comment below with the following information:
1. The model number as well as the firmware version of the Deco;
2. Which problem description is more like your current issue?
3. Have you tried the hardware reset and firmware recovery suggestions? what are the results?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, welcome to the community.
After going through the troubleshooting guide here, if the Deco still kept solid yellow, I tend to think it is a hardware issue and users could contact the local technical support team for further confirmation and ask for warranty service.
If it is out of warranty, I'm sorry there aren't any other suggestions. Whether purchasing a new Deco or another brand would depend on your personal preferences. While I definitely advocate for our own products, however, I fully support your other decisions.
Thanks a lot for your understanding and support.
Best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 49471
Replies: 51
Voters 0
No one has voted for it yet.