@David-TP 

I have tested like you asked and nothing changed. I have sent an email with the requested information

  @David-TP After updating my M9 Plus V2.0 to this firmware when i jump between deco access points by physically moving between AP's or by changing the preferred connection/access point all packets are dropped for minutes or until I disconnect/connect wifi. I'm testing using ping to local gateway and internet.

However the WIFI does appear to remain connected.

This didn't happen on previous firmware. Enabling/disabling fast roaming, beam forming or "mesh technology" on the device does not affect the behavior.

I can replicate this issue consistently. Has this been reported by anyone else?

My topology is as follows:
AP1 (main connected to internet) --- AP2 (Connected to WIFI)  --- AP3 (Connected with cable to AP1).

1. I start a ping request on my iPhone to 1.1.1.1 while connected to AP3.

2. Walk to AP2 one packet is dropped during handover.

3. Walk to AP1 one packet is dropped during handover.

4. Walk back to AP2

5. Walk back to AP3 (starting point) all packets dropped until WIFI-reconnection or several minutes waited.

I noticed the following warnings in the log following new steer event for my MAC-address.

Thu May 25 12:01:44 2023 user.err csrMeshGw[6341]: MSGQ :: CsrMeshAddMsgToTxQueue idx: 0x0, Msg Len: 30, Repeat: 2
Thu May 25 12:01:44 2023 user.err csrMeshGw[6341]: MSGQ :: CsrMeshGetMsgFromTxQueue curTxIndex : 0, tag count : 2, length : 30
Thu May 25 12:01:44 2023 user.err csrMeshGw[6341]: MSGQ :: CsrMeshGetMsgFromTxQueue curTxIndex : 0, tag count : 1, length : 30
Thu May 25 12:01:44 2023 user.err csrMeshGw[6341]: 
CsrMeshMsgQRead: qId=0 errno=42, No message of desired type!!!!

FYI: I have also submitted a ticket to technical support.

  @David-TP I have 3 in the m9 plus and all configured as Ac. no1 connects to no2 by cable and no3 connects to no2 by wi-fi. all version 2 with firmware 1.6.1. every day I have to restart the nodes because they lose performance during the day and usually at night the speed is terrible and it is necessary to restart to get back to normal.

I don't know how to get log of ac to put it here.

Thanks

  @David-TP

Hello,

Since the upgrade, I've got wifi issues. Here is my Setup

Main: Deco M9 v2 with 1.6.1 build 20230403 rel 70058 (access point mode)

Satellites: several Deco M9 v1/v2 and M5

Since the firmware upgrade, I had:

- wifi connection issues (password refused)

- wifi stability issues (performance A/O timeouts)

- no issue when connected to the main Deco or a satellite with an ethernet cable

I already recreated the network from scratch twice and problems still occur

  @tomCDP 

Where did you get rel no 70058? My rel is 20230403 66598!

cheers /jannek999

  @Jannek999 

Deco M9 plus v1 has 20230403 70058

Deco M9 plus v2  has 20230403 66598

  @Schueler 

Thanks for info! /jannek999

  @David-TP 

3 decos set as access point.

7-8 Clients all day.