Home Network Community > Deco > Wire Backhaul Units
< Deco

Wire Backhaul Units

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wire Backhaul Units

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wire Backhaul Units
Wire Backhaul Units
2022-12-25 20:19:11 - last edited 2022-12-27 03:14:25
Model: Deco X20  
Hardware Version: V1
Firmware Version:

Does the Ethernet cable between the 1st mesh device and the second HAVE to be a direct connection or can it go through a switch ? 
I would have a Deco x20 downstairs obviously plugged into the modem/router. I also have an Ethernet cable from the modem/router to the first floor where the switch is. It feeds my Mac and Steam deck. Could I also plug the second Mesh device into the switch ?

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Wire Backhaul Units-Solution
2022-12-25 20:39:04 - last edited 2022-12-27 03:14:25

  @topgazza1 

 

This TP-Link FAQ document will help: General questions about Ethernet Backhaul feature on your Deco

Recommended Solution
  0  
  0  
#2
Options
4 Reply
Re:Wire Backhaul Units-Solution
2022-12-25 20:39:04 - last edited 2022-12-27 03:14:25

  @topgazza1 

 

This TP-Link FAQ document will help: General questions about Ethernet Backhaul feature on your Deco

Recommended Solution
  0  
  0  
#2
Options
Re:Wire Backhaul Units
2022-12-25 20:44:16

  @Alexandre. Thanks

That's  a great page. I will be setting my first Deco, as I say in AP mode so wiring the second through a switch is handy. It says set them up as WiFi first before wiring them up which is interesting

  0  
  0  
#3
Options
Re:Wire Backhaul Units
2022-12-25 20:48:48

  @topgazza1 

 

Configure Main Deco. Bring your Satellite Decos for setup to the same room where Main Deco is, so that they have good WiFi link to each other. After Satellite Decos successful setup, switch Deco mesh to AP mode: How to set up Deco to work in Access Point mode

After that, take Satellite Decos to their permanent places and connect them with Ethernet cable to your home network.

  0  
  0  
#4
Options
Re:Wire Backhaul Units
2022-12-25 21:02:01
TP Link manage yet again to make installation simple and common sense. Thank you for the advice Alexandre
  0  
  0  
#5
Options

Information

Helpful: 0

Views: 645

Replies: 4

Related Articles
Connection by wire
395 0
Wire backhaul not working in our case
488 0
Mixing Wire and Wireless Backhaul
754 0
Should i wire a TV to a satellite deco?
540 0
 Deco x60 Wire Backhaul
720 0
Mixing Deco Units
89 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.