Deco X50-DSL Adjust SNR Setting
Sometimes I experience signal attenuation on my DSL line. Since the SNR margin is set automatically, it usually stays at around 6-7 db. This causes disconnections and slow internet speed after a certain period of time. With my old modem, I was able to adjust the SNR margin and set it at 12dB, which resolved the issue completely. Please add the option to adjust the SNR margin.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, Welcome to the community.
I will add it to the community feature request list first and check whether more users have the same needs.
Have you tried to enable SRA under Deco APP>>More>>Advanced>>DSL Settings>>DSL status>>enable SRA?
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
@David-TP
Yes, I have enabled SRA, but the initial DSL connection locks the current speed. It does not adapt even though the maximum speed changes, so SRA, which starts with 7dB, decreases to 6dB and 5dB.
Therefore, errors increase after a while. It is necessary to provide the SNR adjustment to the user. It is unfortunate that this setting is available on cheaper modems in the market but not on TP-Link. I hope this setting will be added as soon as possible.
- Copy Link
- Report Inappropriate Content
@David-TP such a problem occurs, packet losses increase a lot and the internet connection is lost
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@David-TP After 1 day of DSL operation, it starts to give too many error logs and the internet connection is not used and I have to restart it. I was using DLA disable, SNR 11-12db, ESNP enable, G.INP enable in my old modem and I was not having any problems. Why are the VDSL settings on a cheaper modem not available on the deco x50-dsl?
thousands of error records in minutes
my old device settings
- Copy Link
- Report Inappropriate Content
@Redali I'm having trouble with this issue because there are interruptions in the connections due to low SNR (Signal-to-Noise Ratio) in the dB. This setting should be made available to users. I also need to increase the SNR setting. If possible, even the ESNP - Enhanced Sudden Noise Protection and G.INP Stability Adjustment settings should be made available to users.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Redali I fully support it. Please add it TPLink.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 23
Views: 1150
Replies: 9