How to enable Bridge Mode on TP-Link XC220-G3v v2.0

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to enable Bridge Mode on TP-Link XC220-G3v v2.0

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to enable Bridge Mode on TP-Link XC220-G3v v2.0
How to enable Bridge Mode on TP-Link XC220-G3v v2.0
2023-11-27 08:12:21
Model: Deco M9 Plus  
Hardware Version: V1
Firmware Version:

How to enable Bridge Mode on TP-Link XC220-G3v v2.0

 

My ISP has provided me with the TP-Link XC220-G3v v2.0. I want to enable bridge mode on it as I have bought a new Deco setup. How can I do it? Can someone guide me step by step?

 

Alliance Broadband is my ISP. They have provided me with Static IP and they use MAC filtering.

  0      
  0      
#1
Options
1 Reply
Re:How to enable Bridge Mode on TP-Link XC220-G3v v2.0
2023-11-28 06:34:54

  @biswasrahul016 

Hi, welcome to the community.

Since XC220-G3v is a customized model for local internet service providers, the software features is designed per ISPs and its management UI would be different from the general models. It would be better to check with the service provider first whether it could be set as a bridge modem only.

If there isn't a bridge mode, I think you could try to set up Deco M9 plus into Access Point mode:

How to set up Deco to work in Access Point mode

Thank you very much and best regards.

  0  
  0  
#2
Options