Hi I have recently purchased the Deco S7 setup. 
 

I use Starlink and I am not able to turn off the WiFi on the router, it's not an option on my gen one router. 
 

I have a few questions with setup, I am going to run it in access point mode to help extend the WiFi as I have wired connections everywhere I need them. I just need to push the WiFi a bit further 

I have been reading this: https://www.tp-link.com/us/support/faq/1794/

I have 3 questions

1. Is access point mode my best option or should I look to remove the Starlink router from the setup and one of the mesh as main and use it as router? 

2 . if in access point mode what would be the best setup

 2a -  router(one Ethernet port)> switch > 2 x mesh

2b - router > mesh 1 > switch > mesh 2 

2c router > mesh 1 > switch & mesh 2 wired direct to mesh 1 

2d router > switch > mesh 1 > mesh 2 wired direct to mesh 1 and not switch 

3. if using as access point should I set the WiFi said as the same as my current Starlink ssid or should I run them as 2 separate networks to save conflict? 
 

thank you