Business Community > Gateways > ER605 Link Backup missing WLAN
< Gateways

ER605 Link Backup missing WLAN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 Link Backup missing WLAN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER605 Link Backup missing WLAN
ER605 Link Backup missing WLAN
2024-05-21 00:18:02 - last edited 2024-05-24 00:47:41
Tags: #WAN Setup #Load Balancing
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.3.1 Build 20231207 Rel.61384

I have multiple WANs configured, but when I go to Transmission -> Load Balancing -> Link Backup, I can only select a single WAN.

 

I would expect "Primary WAN" and "Backup WAN" to have an option to select "WAN/LAN1", but it's not there.

 

 

 

 

  0      
 
  0      
 
#1
Options
2 Accepted Solutions
Re:ER605 Link Backup missing WLAN-Solution
2024-05-21 01:02:17 - last edited 2024-05-24 00:47:44

Hi @pc1986 

Thanks for posting in our business forum.

You can try the following steps.

1. Backup your config and reset. See if it can work okay in factory default.

2. Restore the backup. Will the missing WAN/LAN1 issue exist?

 

Or you may try the following steps, regardless of the result above.

Change the WAN/LAN1 to the LAN port. It'll reboot. Then change the port to the WAN again. Reboot. Check again.

If this persists, I think we need to reset the router and start from the factory default. You can let me know the results of the suggestions above.

Recommended Solution
  2  
  2  
#2
Options
Re:ER605 Link Backup missing WLAN-Solution
2024-05-23 20:39:48 - last edited 2024-05-24 00:47:41

  @Clive_A 

 

Thank you. I did a factory reset and was able to successfully apply the link backup settings.

Recommended Solution
  1  
  1  
#3
Options
2 Reply
Re:ER605 Link Backup missing WLAN-Solution
2024-05-21 01:02:17 - last edited 2024-05-24 00:47:44

Hi @pc1986 

Thanks for posting in our business forum.

You can try the following steps.

1. Backup your config and reset. See if it can work okay in factory default.

2. Restore the backup. Will the missing WAN/LAN1 issue exist?

 

Or you may try the following steps, regardless of the result above.

Change the WAN/LAN1 to the LAN port. It'll reboot. Then change the port to the WAN again. Reboot. Check again.

If this persists, I think we need to reset the router and start from the factory default. You can let me know the results of the suggestions above.

Recommended Solution
  2  
  2  
#2
Options
Re:ER605 Link Backup missing WLAN-Solution
2024-05-23 20:39:48 - last edited 2024-05-24 00:47:41

  @Clive_A 

 

Thank you. I did a factory reset and was able to successfully apply the link backup settings.

Recommended Solution
  1  
  1  
#3
Options

Information

Helpful: 0

Views: 507

Replies: 2

Tags

WAN Setup Load Balancing
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.