Main flashing blue after reset

Main flashing blue after reset

Main flashing blue after reset
Main flashing blue after reset
2024-06-07 07:05:20
Model: Deco P9  
Hardware Version: V2
Firmware Version: undated

Good day, we have been having a problem with internet speeds with our DECO MAIN, we have fiber optic & speed test for our router shows 916 upload & 601 download, so all good with the router.  Main Deco was showing vastly different internet speeds down to 1-4 then upto 20 mpbs +.  I took out all other P9 spreaders and rebooted MAIN and ROUTER.  some difference but not stable.  Pressed RESET button on MAIN and now I have only flashing BLUE. Tried a few times and even switching to another unit, but that only flashes RED.  What do I do now to get my internet back? - advice would be much appreciated. With thanks in advance.

  0      
  0      
#1
Options
1 Reply
Re:Main flashing blue after reset
2024-06-11 07:50:34

  @deco-dent 

Hi,

 

The blinking blue light on the Deco means it is ready to be set up.

Here is a set-up guidance for you: Deco Setup Walkthrough.

 

About the satellite Deco with blinking red light, you need to reset it first and then add it to the network. How to add an additional unit to your Deco network

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options