Home Network Community > Deco > Using range extender with Deco AX3000 (X50-DSL) Mesh modem router
< Deco

Using range extender with Deco AX3000 (X50-DSL) Mesh modem router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Using range extender with Deco AX3000 (X50-DSL) Mesh modem router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Using range extender with Deco AX3000 (X50-DSL) Mesh modem router
Using range extender with Deco AX3000 (X50-DSL) Mesh modem router
2024-06-27 02:30:54
Tags: #Range extender
Model: Deco X50   Deco X50-DSL  
Hardware Version: V1
Firmware Version: 1.0.4

 

Hey

I have just installed a new Deco Mesh Modem Router. All working ok. My question relates to an existing TP Link Range extender, AC1750, Model RE450. I was told in store that even though the Deco is a mesh system I could still use the Router as required. I want to know whether this is correct and how to establish a connection. On the previous router I had pushed a WPS button. Thanks Simon

PS Not sure on hardware version number or where to find that

  0      
 
  0      
 
#1
Options
1 Reply
Re:Using range extender with Deco AX3000 (X50-DSL) Mesh modem router
2024-06-28 08:26:04

  @SiFi17 

Hi

 

There is a small reset hole on the extender. Please use a pin to press the reset hole for 1 second to reset the extender.

Then you may connect your PC/phone to the Range Extender's default Wi-Fi "TP-Link_Extender_XXXX", open the browser and access http://tplinkrepeater.net or http://192.168.0.254, follow the quick setup procedures to setup your Range Extedner.

This FAQ provides detailed instruction through web interface: https://www.tp-link.com/support/faq/1400/

 

Please note that the extender should be placed next to the router during configuration.

Good day.

Welcome to Our Community！ Check Out the Latest Posts: △New Firmware for Archer BE400 V1 to Support IPv6 VPN, Wake On LAN, and More △New Firmware for Archer BE800 V1 to Support VPN Merge, EasyMesh Guest/IoT Network Extend, and More △Enhanced EasyMesh Support with Extended Guest/IoT/MLO Networking and Advanced Features for BE550 V2 △New Firmware for Archer BE900 V2 to Support Multi-WAN, DoH/DoT, EasyMesh in AP Mode and More If you found the post or response helpful, click Helpful. If an answer solves your problem, click Recommended Solution so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1046

Replies: 1

Tags

Range extender
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.