Factory reset not working

Factory reset not working

Factory reset not working
Factory reset not working
2024-07-09 16:40:31
Model: TL-WR802N  
Hardware Version: V4
Firmware Version: Unknown

I have a TP-Link portable router and it's been working fine. I noticed that the network it was broadcasting wasn't active anymore and checked the unit. It was blinking slowly green. I'm not sure if that's normal. Regardless I was unable to access the network. I decided to do a factory reset and afterwards the device is still blinking slowly green. There is no TP-LINK network I'd showing up in my list and I cannot connect to tplinkwifi.net. I've run out of ideas. My suspicion is that the router has died.

  0      
  0      
#1
Options
1 Reply
Re:Factory reset not working
2024-07-09 17:51:24 - last edited 2024-07-09 17:54:05

  @PeterSteele 

 

When resetting the router click and hold the reset button for about 10 seconds - use a toothpick or paperclip.

If after this procedure you still can't see the router wirelewss SSID mosr probably the router has died.

If that's the case - If it's under warranty contact your retailer or your local support.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options