RE705X as wireless point / extender from Access Point Archer AX73

RE705X as wireless point / extender from Access Point Archer AX73

RE705X as wireless point / extender from Access Point Archer AX73
RE705X as wireless point / extender from Access Point Archer AX73
2024-07-22 15:18:10 - last edited 2024-07-23 07:55:12
Model: RE705X  
Hardware Version:
Firmware Version:

Huawei WA8021V5 is modem router. Using this unit as modem due to this unit given by Internet Provider. 

 

Ssid: Huawei_123

 

 

 

Tplink Archer AX73 as main router (Connection Type: Dynamic IP from Huawei WA8021V5) 

 

Ssid: Archer_123

 

 

 

1. Can I make Range Extender RE705X as wireless repeater/extender from Router Archer AX73? 

 

If yes, can i make it as mesh setup ssid: Archer_123?

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:RE705X as wireless point / extender from Access Point Archer AX73-Solution
2024-07-22 20:57:28 - last edited 2024-07-23 07:55:12

  @TTurtle 

 

Hi,

 

Yes, just log into the Archer AX73, go to the "EasyMesh" menu and select add Satellite device. Then you will be given instructions on how to add the RE705X as Mesh device. The SSID will become identical for all devices that belong to the same Mesh network. ("Archer_123" in your case)

 

If your Archer AX73 still shows an "OneMesh" menu instead of an "EasyMesh" menu, then you can either follow the instructions for OneMesh or update the firmware to the lastest version, which will replace the "OneMesh" with "Easymesh".
 

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:RE705X as wireless point / extender from Access Point Archer AX73-Solution
2024-07-22 20:57:28 - last edited 2024-07-23 07:55:12

  @TTurtle 

 

Hi,

 

Yes, just log into the Archer AX73, go to the "EasyMesh" menu and select add Satellite device. Then you will be given instructions on how to add the RE705X as Mesh device. The SSID will become identical for all devices that belong to the same Mesh network. ("Archer_123" in your case)

 

If your Archer AX73 still shows an "OneMesh" menu instead of an "EasyMesh" menu, then you can either follow the instructions for OneMesh or update the firmware to the lastest version, which will replace the "OneMesh" with "Easymesh".
 

Recommended Solution
  0  
  0  
#2
Options