Adding NC200 to QNAP Surveillance Station (Generic JPEG)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Adding NC200 to QNAP Surveillance Station (Generic JPEG)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Adding NC200 to QNAP Surveillance Station (Generic JPEG)
Adding NC200 to QNAP Surveillance Station (Generic JPEG)
2015-08-22 14:02:01
Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

Hello! Thanks for very nice cam!
I am wondering can i get it added as surveillance camera to my QNAP surveillance station, as the QNAP suppors "generic jpg" input as long as there is cgi in use..?

Here is easy QNAP tutorial.
http://www.qnapsecurity.com/n/en/trade_teach/con_show.php?op=showone&cid=26

Tried to find .cgi address without luck. ..and if not supported, is it maybe possible to add in future firmware releases?

Best regards: Jens
  0      
  0      
#1
Options
3 Reply
Re:Adding NC200 to QNAP Surveillance Station (Generic JPEG)
2015-08-24 10:42:30
It is not supported and it won't be added in future. NC200 only supports HTTP protocol. ONVIF and RTSP are not supported.
  0  
  0  
#2
Options
Re:Adding NC200 to QNAP Surveillance Station (Generic JPEG)
2021-12-17 09:36:35

@jehol 

I havent tested this, I will tomorrow. However I found this which shows that these cameras do support ONVIF and RTSP protocols:

 

https://www.tp-link.com/se/support/faq/2748/

  0  
  0  
#3
Options
Re:Adding NC200 to QNAP Surveillance Station (Generic JPEG)
2021-12-17 09:37:03
Tad late to the party, but might help someone else in the future.
  0  
  0  
#4
Options