Deco X20 V1 dont run stable after firmware update
I have some Deco X20 V1 with 2 version
- Deco_X20_V1.2_1.6.1_Build_20250910_Rel.43292
- Deco X20V1_en_1.6.1 Build 20250831 Rel. 77853
After i upgrade my Deco X20 v1 to lastest version 1.6.1, it can run full speed my bandwidth
Now it only can run 200-280Mbps insteed my network 800Mbps
I tried with a Deco X20 V3.2 EU and it can run with 500-600Mbps
Please check and help me
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, welcome to the comunity.
May I know how long you have had the Deco X20_V1.0/V1.2?
Did you add all three Deco X20s(V1.0+V1.2+V3.2) into the same Mesh network? Or setting a separate Mesh Network using each of them?
Have you tried to reset the Deco X20 V1/V1.2 once (by holding the reset pinhole for 1s), then set it up again to see whether it made any difference?
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
Hi
I tried to setup 1 Deco 1 network and speedtest
Only 2 X20 Japanese version run with low bandwidth, only X20 EU run better
I used 2 X20 v1 JP for 1 years and X20 EU i bought from my friend but it is older then X20 JP
Thanks
- Copy Link
- Report Inappropriate Content
I reset and setup many times and it only have 1 result
- Copy Link
- Report Inappropriate Content
@ThanhHa I have the same problem. It's clearly a firmware bug. Are you going to release a fix soon ?
- Copy Link
- Report Inappropriate Content
@GeorgeDad I created this ticket for TPlink helpdesk but maybe noone in TPLink care about their product
- Copy Link
- Report Inappropriate Content
@ThanhHa it is clear for me they don't. it has been months already. i already ordered a different solution , from a different seller. never going back.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 278
Replies: 6
Voters 0
No one has voted for it yet.