Archer BE230 V2.0 – PPPoE upload limited to ~350 Mbps on a 1 Gbps symmetric connection

Archer BE230 V2.0 – PPPoE upload limited to ~350 Mbps on a 1 Gbps symmetric connection

12 Reply
Re:Archer BE230 V2.0 – PPPoE upload limited to ~350 Mbps on a 1 Gbps symmetric connection-Solution
2026-09-21 17:40:08 - last edited 2026-09-21 17:40:14

Hi everyone,
 

I would like to share an update because this may help other Archer BE230 V2 users experiencing similar PPPoE upload limitations.
 

The original issue was:

  • Download: around 850–890 Mbps
  • Upload: around 350–380 Mbps
  • Connection: 1 Gbps symmetric PPPoE
     

After testing with TP-Link Support, I found that the upload behavior changes significantly depending on the QoS configuration.

With QoS disabled, or with the QoS upload bandwidth set to 1000 Mbps, the upload remains limited to around 350–380 Mbps.
 

However, with:

  • QoS: ON
  • Download bandwidth: 2500 Mbps
  • Upload bandwidth: 900 Mbps
  • Speed Limit: OFF

the connection now performs approximately:

  • 870–890 Mbps download
  • 860–865 Mbps upload
     

I also reverted from the diagnostic beta firmware to the official firmware:

1.3.5 Build 20260812 rel.8951(5553)

The same QoS configuration continues to work correctly on the official firmware.

My latest tests were:

  • 880.49 / 864.00 Mbps
  • 873.54 / 863.13 Mbps
  • 889.14 / 864.32 Mbps
     

So, for practical purposes, the issue is resolved for me with this QoS configuration.

One additional note: during the first attempt to return from the beta firmware to 1.3.5, the router entered a boot loop. I was able to recover it using the TP-Link Rescue Mode and reinstall the official 1.3.5 firmware successfully.
 

I am still waiting for TP-Link's internal analysis regarding whether this behavior will be addressed permanently in a future firmware version.
 

I hope this information helps anyone experiencing the same PPPoE upload issue.

Recommended Solution
  1  
1
#13
Options
Re:Archer BE230 V2.0 – PPPoE upload limited to ~350 Mbps on a 1 Gbps symmetric connection-Solution
2026-09-21 17:41:25 - last edited 2026-09-21 17:41:28

Hi everyone,
 

Quick update with the workaround that solved the PPPoE upload issue for me on the Archer BE230 V2.

With QoS disabled, upload stayed around **350–380 Mbps**.
 

Using:

* QoS: ON
* Download: **2500 Mbps**
* Upload: **900 Mbps**
* Speed Limit: OFF

I now get around **870–890 Mbps download** and **860–865 Mbps upload**.
 

This is also working normally on the official firmware **1.3.5 Build 20260812**.
 

So, for practical use, the issue is resolved for me with this QoS configuration.

Recommended Solution
  2  
2
#14
Options