Device won't connect to main network, but will connect to guest network

Device won't connect to main network, but will connect to guest network

Device won't connect to main network, but will connect to guest network
Device won't connect to main network, but will connect to guest network
2026-09-04 17:38:08 - last edited 2026-09-05 12:58:40
Model: Deco X50   Deco M9 Plus  
Hardware Version:
Firmware Version:

Setup:

Indoor mesh 4units of m9 plus (one is the main)

Stable powerline to outside garage, with a X50 unit connected by wire.

 

A Rainbird RC2 (irrigation computer) will not connect to the main wifi network through the X50. My phone connects no problem.


The RC2 will however connect to a Deco guest network broadcast by the X50 and also directly to the powerline wifi. 


I have tried:

- switch off 5ghz

- change password and ssid

- reset x50, reset rainbird, reboot network

- switch off beamforming and fast roaming

- smart dhcp is off. 

What am I missing?

  0      
0
#1
Options
1 Accepted Solution
Re:Device won't connect to main network, but will connect to guest network-Solution
2026-09-04 20:57:42 - last edited 2026-09-05 12:58:40

  @Caramba84 

 

Dual band is first suspect, but you said you switched 5GHz off and that should take care of dual band.

 

You said "change password and ssid"- but have you done this: disable guest network and set Main network with SSID and password of Guest network. Also, keep 5GHz disabled on Main Network during the test.

 

Also, a workaround. I believe (but may be mistaken) that M9 firmware does have third network: IoT. X50  should have it for sure. If Deco mesh allows you to enable IoT network, do that and try connecting  Rainbird RC2 to IoT network. IoT connected devices are visible from Main Network, and that should solve any access issues to  Rainbird RC2  you may have.

Recommended Solution
  0  
0
#2
Options
2 Reply
Re:Device won't connect to main network, but will connect to guest network-Solution
2026-09-04 20:57:42 - last edited 2026-09-05 12:58:40

  @Caramba84 

 

Dual band is first suspect, but you said you switched 5GHz off and that should take care of dual band.

 

You said "change password and ssid"- but have you done this: disable guest network and set Main network with SSID and password of Guest network. Also, keep 5GHz disabled on Main Network during the test.

 

Also, a workaround. I believe (but may be mistaken) that M9 firmware does have third network: IoT. X50  should have it for sure. If Deco mesh allows you to enable IoT network, do that and try connecting  Rainbird RC2 to IoT network. IoT connected devices are visible from Main Network, and that should solve any access issues to  Rainbird RC2  you may have.

Recommended Solution
  0  
0
#2
Options
Re:Device won't connect to main network, but will connect to guest network
2026-09-05 12:58:34

  @Alexandre. 

 

Many thanks for your suggestion. The Rainbird connected to the IoT network, so the matter is in principle resolved.

 

I'm still trying to understand the details of this matter and why the device connects to guest and iot networks, but not to the main one.

 

Also wondering whether keeping a separate iot network consumes more power.

 

Finally, the option to force connect devices to a specific AP dissappeard from the menu's.

 

in any case, thanks again!

 

Mark 

 

 

 

  0  
0
#3
Options