Archer VR900R V1 - how to setup as wlan access-point

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer VR900R V1 - how to setup as wlan access-point

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer VR900R V1 - how to setup as wlan access-point
Archer VR900R V1 - how to setup as wlan access-point
2017-04-19 03:35:55
Model : TP-Link AC1900

Hardware Version : Archer VR900v v1 00000001

Firmware Version : 0.9.1 1.2 v0048.0 Build 161114 Rel.50112n

ISP : not used - only used as access point with the local wired network

How I can setup the Archer VR900v V1 as WLAN-Access-Point? I want to use the same IP-Subnet on the wlan and the wired net. The main-dsl router make the dhcp server.
  0      
  0      
#1
Options
1 Reply
Re:Archer VR900R V1 - how to setup as wlan access-point
2017-04-20 04:17:48
I have'd solve the problem with this configuration steps:
1. Betriebsart/Modus: not changed! 1 - DSL-Modemrouter
2. Netz/Net:
=> Lan-Einstellungen/-settings
IP-Adress - from the range of the local subnet - but not a IP from the dhcp-range of the main-router
DHCP-Relay set to "on" - IP-Adress of the remote server: set to the main-router ip-adress
==>>> erster/first restart/reboot

Then login to the router from a wired pc and configure the rest:
WLAN-settings - normal, with unequal SSIDs for the 2.4 and 5G-Net; with passwords
==>>> zweiter/second restart/reboot

That's all!
I can login!!! fine!

NAT - ALG - all otions are set to "off" - but it are too functional with the setting of "on"
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1534

Replies: 1