NC450 initial position
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
NC450 initial position
Model : NC450
Hardware Version : NC450 2.0
Firmware Version : 1.2.4 Build 170322 Rel.85B2CB
ISP :
Hi
Is it possible to change the "initial position" button when using turn/tilt to stop on an nother position than the standart.
Hardware Version : NC450 2.0
Firmware Version : 1.2.4 Build 170322 Rel.85B2CB
ISP :
Hi
Is it possible to change the "initial position" button when using turn/tilt to stop on an nother position than the standart.