Ver low bandwidth from Deco M4 1

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Ver low bandwidth from Deco M4 1

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Ver low bandwidth from Deco M4 1
Ver low bandwidth from Deco M4 1
2020-11-30 22:32:49
Model: Deco M4  
Hardware Version: V8
Firmware Version: 2.4.10

I have the following setup:

- Thomson Modem from Ziggo (Netherlands);

- I have swithched off the 2.4 and 5Ghz bands on the modem;

- I installed #1 directly connected to the modem;

- I installed #2 and #3 wireless for upper floors;

- I configured it as an Access Point.

 

Close to #1 - almost no bandwith (5-10Mbps);

Close to #2 (first floor) - 10-25Mbps bandwith;

Close to #3 - no bandwith.

 

When installing, I had the 2.4/5Ghz signals not switched off.

 

Can I do an entire new install and try again?

What can be wrong?

  0      
  0      
#1
Options
1 Reply
Re:Ver low bandwidth from Deco M4 1
2020-12-02 09:09:24

@Hermanator2 

Good day,

Thank you very much for your time and patience.

Could you please help me check the signal strength between the two satellite Decos with the main Deco to see if it is the location that caused the slow speed?

How much internet bandwidth you are supposed to get?

Would the Ethernet speed be slow as wireless connection?

Please make sure the QoS, parental control and antivirus have already been disabled;

If possible, please also try to switch to a different Deco and set up again to have a look;

 

Thanks a lot for your cooperation and support.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 344

Replies: 1

Related Articles