I have followed the below info from am old thread to use an ex MR600 as a WiFi point stemming from Starlink.

I can't configure the Starlink router like a Draytek so I've not been able to do any of the DrayTek config side of this.

I also didn't see the NAT forwarding part near the end, so currently this isn't set.

Starlink is set to 192.168.1.1 and the MR600 is 192.168.2.1 with Starlink connected into the WAN/LAN port on the MR600 and passing through the full speed which was a great help as I was in a pinch with a failed EAP115.

But will the NAT forwarding not being enabled cause any issues to the point that i should return or connect remotley and set it as it states?