Tapo c200: blinking red led, will not connect

Tapo c200: blinking red led, will not connect

Tapo c200: blinking red led, will not connect
Tapo c200: blinking red led, will not connect
2024-11-27 12:59:50 - last edited 2024-12-06 08:03:44
Model: Tapo C200  
Hardware Version:
Firmware Version:

Hi,

 

I changed my router password and now I cannot connect.

  0      
  0      
#1
Options
1 Accepted Solution
Re:Tapo c200: blinking red led, will not connect-Solution
2024-11-28 08:35:50 - last edited 2024-12-06 08:03:44

  @ManfredW 

Hi,
If the Tapo C200 has a flashing red LED, please press the reset button on the camera for 10 seconds to factory reset it, and when it has a flashing red and green light, you can try to reconfigure it to connect to the new Wi-Fi network.

 

If you fail to set up the camera, please refer to the instructions below to troubleshoot.
What should I do if I fail to configure Tapo Camera?

Best Regards

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Tapo c200: blinking red led, will not connect-Solution
2024-11-28 08:35:50 - last edited 2024-12-06 08:03:44

  @ManfredW 

Hi,
If the Tapo C200 has a flashing red LED, please press the reset button on the camera for 10 seconds to factory reset it, and when it has a flashing red and green light, you can try to reconfigure it to connect to the new Wi-Fi network.

 

If you fail to set up the camera, please refer to the instructions below to troubleshoot.
What should I do if I fail to configure Tapo Camera?

Best Regards

Recommended Solution
  0  
  0  
#2
Options