Tapo c260 blinks green and red but not discoverable

Tapo c260 blinks green and red but not discoverable

Tapo c260 blinks green and red but not discoverable
Tapo c260 blinks green and red but not discoverable
2026-09-30 21:27:01 - last edited 2026-10-03 07:17:05
Model: Tapo C260  
Hardware Version:
Firmware Version:

Hi
 

As I unboxed my tapo c260 for the first time, it appeared on the tapo app. The config failed and showed "network unstable" after hanging on the screen that follows the "icon selection".

I removed the device from tapo.

 

After this the camera is not findable in the app.

Factory reset, wifi reset, power switched. Powered from official cable and block.

 

The led blinks red and green, but still nothing.

  1      
1
#1
Options
1 Reply
Re:Tapo c260 blinks green and red but not discoverable
2026-10-08 07:44:14

  @mehanikm 

To help narrow down the issue, could you please confirm the following:

Are you unable to see the camera’s default Wi-Fi network (something like “Tapo_Camera_XXXX”) in your phone’s Wi-Fi list?
Or can you connect to the camera’s default Wi-Fi, but the Tapo app still can’t find or configure the camera?

 

Also, it would help to try the setup on another phone or tablet—sometimes the issue is with the device you're using rather than the camera itself.In the meantime, please refer to this official guide for detailed troubleshooting steps: 👉 Tapo Camera Not Connecting to Wi-Fi: Troubleshooting Guide

 

If the problem persists, contact our customer service team​​​​​​​ and provide the results of the troubleshooting steps above.


 

  0  
0
#2
Options