View Camera on PC/NVR/NAS
The Tapo cameras, which support the RTSP and ONVIF (Profile S) protocols, allow it to be viewed not only through the Tapo app but also through third-party programs on PC/NAS/NVR. This greatly enriches the usage scenarios of the camera. You are welcome to share your experience and preferred usage scenarios when viewing a camera on a PC/NAS/NVR.
View Camera on PC/NVR/NAS
Knowledge BaseView Tapo cameras on PC/NVR/NAS
Introduction What are ONVIF (Open Network Video Interface Forum) and RTSP (Real-Time Streaming Protocol)? ONVIF is an open standard organization that promotes interoperability among network video devi
ONVIF/RTSPHighlighted ThreadOfficial
0Helpful
8152Views
The Tapo wired-powered camera supports RTSP and ONVIF (Profile S) protocols, enabling compatibility with third-party NVR or NAS devices that also support RTSP/ONVIF. If you fail to stream the Tapo cam
ONVIF/RTSPHighlighted ThreadOfficial
0Helpful
79049Views
While I can view my Tapo C200 through the mobile app, I would also like to use a PC to view it. Is there some way I can view it using my PC?
ONVIF/RTSP
369Helpful
835690Views
Hello, I have a Tapo C202 camera and the RTSP stream has suddenly stopped working. Previously everything worked correctly, but now the camera constantly refuses RTSP connections. Any client attempting
FirmwareDevice ConnectivityONVIF/RTSP
By
Mathildeuh
· Latest post Yesterday
by Mathildeuh
0Helpful
32Views
Hi! This is a feature request for battery powered cameras to have a continuous recording/always on feature. Understandably this would drain power quickly, but customers can opt for a solar panel, to r
Motion DetectionONVIF/RTSPNotificationContinuous Recording
By
tapouser-927593
· Latest post Tuesday
by BKluwe
39Helpful
22225Views
Hi I recently purchased a Tapo C560WS after checking the Video Compression specifications for this device on your website, Specifications - Tapo C560WS. The specifications state the camera supports H.
FirmwareONVIF/RTSP
By
Gaz105
· Latest post a week ago
by Solla-topee
0Helpful
530Views
Hello, I would like ot know if its possible to get a firmware update or something so that the C425 camera can be used with the rtsp protocol for frigate. I had been using a c125 indoor camera that's l
FirmwareONVIF/RTSP
0Helpful
172Views
Hi, with the latest firmware v1.4.1 for Tapo C222 seem to use hevc h265 for the 2560x1440 stream, and messing up with my ONVIF setup AGAIN, as it do not support h265. The firmware release note make no
FirmwareDevice ConnectivityONVIF/RTSP
By
ShiiiKi
· Latest post a week ago
by Solla-topee
0Helpful
207Views
I have a few Tapo ipcam v530ws and a c425 I would like to record on my local Synology NAS si Il need to setup a password on the cameras but I don't see how to do it and didn't find the right thread. T
RecordingONVIF/RTSP
By
AlainSat
· Latest post a week ago
by Solla-topee
0Helpful
155Views
Hello, I just bought a C425. I wanted to use this cam to capture wild life without the need of opening a cam regulary to replace batteries and read sd card ! I just found that RTSP is not supported by
ONVIF/RTSPNight ModeMotion DetectionPresales
0Helpful
62Views